Skylight installation is a roofing job, not a window job. It requires cutting through your roof deck sheathing, framing a structural curb between the trusses or rafters, and building a weatherproof barrier with flashing, underlayment, and sealant. Cook Springs Roofing & Maintenance has been installing skylights in Cook Springs for 20 years — every one leak-free.
We install deck-mounted skylights and curb-mounted skylights. Deck-mounted units sit flush against the roof deck and work best for shingle roofs on standard pitch. Curb-mounted units sit on a raised frame and work on flat or low-slope roofs. Both types get the same flashing treatment: ice-and-water shield, step flashing, counter-flashing, and sealant at every transition.
Our Skylight Installation Process
Site Assessment
Free on-site assessment. We check your roof structure, identify the optimal position between rafters, and present skylight options with honest pricing. Sun angle analysis included.
Curb Construction
Precise opening cut through the roof deck. Structural curb framed between trusses with load-bearing headers. Every cut edge of the sheathing sealed. The curb is the structural foundation — we don't skimp on the framing.
Flashing & Waterproofing
Full flashing system: ice-and-water shield base layer, step flashing and counter-flashing on all four sides, woven into the existing shingle field. Water flows over the flashing and onto the shingles below — never behind them.
Completion
Unit installed and sealed. Light shaft insulated and trimmed. We verify the seal from inside the attic — if we can see any daylight at the flashing joints, we re-seal before we leave. Your skylight is watertight and energy-efficient.
What Cook Springs Customers Say
"From the first phone call to the final walkthrough, everything was seamless. The team was courteous and efficient. Already recommended them to two friends."
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
"Best experience we've ever had with a home service company. On time, on budget, and the results exceeded what we expected. Truly top-notch."
Why Choose Cook Springs Roofing & Maintenance for Skylight Installation?
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.
Code Compliant
Every skylight installation meets AL building code for structural framing, energy performance, and egress requirements. Permits pulled when required.
Brand Options
VELUX, Fakro, Sun-Tek — fixed, vented, and tubular models. Tempered and laminated glass. Built-in blinds and shades. We help you choose the right unit for your roof, room, and budget.